.........PARTS LIST..........

              2  1.3 mHy #12 solid inductor
              2  .20 mHy inductor
              2  .30 mHy inductor
              1  matched set: 24+24 uFd Fast Cap (four caps)
              1  matched set: 6.2 uFd Fast Cap
              2  matched sets: Hovland 2.2 uF MusiCaps
              2  1 uF Harmony bypass capacitors
              2  UTC 3619 autotransformers
              2  10 Ohms / 10W Resistors
              2  Fuse holders
              2  1.5 A. fast-blow fuses
              2  base boards (fully drilled)
             12  "L" shaped solder terminals
             12  ground lugs
              2  10 terminal barrier blocks
              4  bi-wire shorting straps
              4  brass quick disconnect tabs
             14  female plugs
             17  Inch braid
              4  flat-spot washers
             18  #6 sheet metal screws
             12  #6 lockwashers
              4  #8 sheet metal screws
             10  cable ties
              8  Rubber pad feet
              1  rubber cushion strip
              2  Driver connection edge labels
              2  ALK Engineering labels
              1  Step-by-step assembly instructions

            All you need will be #14 wire, Rosin core solder.


            REQUIRED TOOLS (not supplied):

            Soldering iron with chisel tip. About 50W.
            Phillips screwdriver.
            Standard screwdriver.
            Needle-nose pliers.
            De-soldering aid or awl.
            Diagonal wire cutters.
            Wire stripper.
            Crimping tool.
            X-acto knife with triangular blade.
            Small (.28 Inch) hot-glue gun
            One .28 Inch glue stick.